Waterless Urinal Starter Kits and Retrofit Solutions for Standard Urinals

Based on Gentworks survey data from hundreds of sites, the average annual water use per urinal is approximately 120 cubic metres (m3) per year. However, usage varies from around 29m3 to 235m3, depending on the level of flush control already implemented. Nearly all standard urinals, whether newly installed or older models, can be easily converted to waterless. The fitting process is simple but must be done carefully. Conversion kits are available from Gentworks and can be fitted by your maintenance team or a plumber. This change to waterless eliminates the need for flushing and eases the load on sewage treatment facilities.

GW6-15 Waterless Urinal Starter/Conversion Kit

GW6-15 Waterless Urinal Starter/Conversion Kit

GW615-KIT

A smaller version of the long-established GW6 cartridge, the GW6-15 is designed to fit urinals that take a 1.5" BSP waste outlet. It has been thoroughly tested at customer sites and in the laboratory, with many refinements being made since its introduction in 2017. The GW6-15 allows odour-free operation in waterless urinals as well as those being low flushed, even if only once per week. It also works with normal flush frequencies but the main purpose of the cartridge is usually to save water, and therefore reduce carbon footprint.

A special silicone formula used in production of the dual "skirt" valves gives good tolerance of common cleaning chemicals within the pH range of 4 to 10. Typical life is 6 to 9 months but harsher cleaning products may reduce this.

The hole diameter required in the ceramic of the urinal to accommodate this conversion kit is 50mm +/-1.5 mm

Included:
- GW6-15 valve core cartridge with dual chemical-resistant silicone skirts
- waste outlet BSP 1.5", 80mm tail with thread break at 50mm
- Removal Key - multipacks supplied with a single key and no key supplied if selected
- Multifit Coupler x BSP Nut to 1½" Multifit Outlet T29LN

Features:
- typically lasts 4 to 6 months
- no chemical sealant required
- unique and patented 'dual skirt' valve to prevent odours
- unique and patented 'snorkel valve' to adjust for pressure and increase drainage rate
- tolerant of common cleaning chemicals
- tolerant of sluicing or flushing to help keep waste pipes clear - drainage rate of over 9 litres/min
- can be used as waterless or with flushing (no trap or U-bend needed, and requires well vented pipework)
- relatively small disposable component and long life reduces impact on landfill
- extensively tested in the field and in the laboratory (see test results in PDF)

Recommended to be used in conjunction with Bactericidal Cleaner; sluicing once every 2 weeks, to extend valve life and keep waste pipes clear.

£35.00

 (ex VAT)
Aquafree UMD Waterless Urinal Starter/Conversion Kit

Aquafree UMD Waterless Urinal Starter/Conversion Kit

AQKIT01M3

Aquafree/AquaShield Urinal Maintenance Devices are simply retrofitted into existing pipework. They combat smells and blockages whilst eliminating the need for water. The contents of the standard Waterless Start-up Kits enable urinals to operate with no flushing for a period of 3 months, after which new Aquafree cartridges will be required. Microbes dispensed by the cartridges break down the uric acid salts and other contents of urine, while regular use of Bactericidal Cleaner helps keep the pipework free from body fats, hair, and other debris.


Standard Aquafree kit for conversion and first 3 months of waterless operation includes:
1 x Aquafree/AquaShield Urinal Maintenance Device cartridge designed to dispense beneficial microbes and other active ingredients over a 3 month period.
1 x Waste outlet fitting into which the cartridge is inserted. Please select the appropriate one in the option. If you find that you have ordered the wrong size, please contact us for a free substitute.
At least 1 x 5 litre container of Gentworks Bactericidal Cleaner concentrate to use for weekly dosing and regular cleaning. 
Click the tab above for details of the exact quantity of Bactericidal Cleaner supplied depending on the number of urinals and timescale selected.
     
How to Use Gentworks Bactericidal Cleaner:
Cleaning of urinal: Dilute 10:1, spray, and wipe as with other cleaning fluids.
Weekly dosing: Mix approximately 100ml of Gentworks Bactericidal Cleaner with 900ml of warm water, then pour over and around the dome of the Urinal Maintenance Device. A 5-litre container typically lasts 10 to 11 months for 1 urinal bowl.
 Note that cleaning products containing acids, strong alkalis and bleaches must not be used as these will kill the active ingredients.
 
Choose to buy supplies to last for up to 12 months after installation:
To take advantage of applicable volume discounts, you can choose to order enough cartridges and Bactericidal Cleaner to last for up to 12 months after conversion.

£42.00

 (ex VAT)
Falcon High Performance Key-Valve Waterless Urinal Starter/Conversion Kit

Falcon High Performance Key-Valve Waterless Urinal Starter/Conversion Kit

HPKVSE000-KIT
Falcon High Performance Key Valve  Starter/Conversion Kit
 This model uses an innovative "bell-valve" promising a much faster flow than previous models, while still preventing odours.
 The Key-Ring dispenses ingredients  that help prevent blockages in the waste pipes. As the contents dissolve with use, the Key-Ring also acts as an indicator of when the cartridge needs changing.
38mm for standard 1 ½” BSP waste outlet. No trap or U-bend needed, and requires well-vented pipework.

Typical life is 3 to 4 months but harsher cleaning products may reduce this.

The hole diameter required in the ceramic of the urinal to accommodate this conversion kit is 50mm +/-1.5 mm

Included:
- HPKV SE000 cartridge
- Waste outlet 1.5" BSP x 65mm Long with backnut & rubber washer
- Removal key - multipacks supplied with a single key and no key supplied if selected
- Multifit coupler x BSP nut to 1½" Multifit outlet T29LN

£66.00

 (ex VAT)
GW6 Waste Adaptors: Compatible with Other Waterless Urinal Brands

GW6 Waste Adaptors: Compatible with Other Waterless Urinal Brands

GW6RETROURI

We've created adaptors to retrofit GW6 into other brands of waterless urinals.

GW6 valves typically last around 6 months, with replacement valves costing less than £35.00. Moreover, they don't require blocking fluid or expensive specialised cleaning products. This makes GW6 a good option for the hire market when installed in welfare cabins.

We offer an adaptor to convert the Uridan waterless Crew Troughs to the GW6, eliminating the need for blocking fluid. Additionally, another adapter is available to convert URIMAT polycarbonate waterless urinals.

Please be advised that professional installation is necessary for these adaptors. The original system must be removed from the urinal, and the new GW6 adapter installed and connected to the drain. See fitting instructions in the Product Data Sheets tab above. 

Adaptor Kit Includes:
- Grey Uridan or Urimat Adaptor with GW6 Housing pre-installed
- GW6 Valve Core pre-installed
- McAlpine ST28M 1¼" x 1½" BSP Waste Connector

£86.00

 (ex VAT)
Exposed Urinal Suitable for Waterless Starter/Conversion Kits

Exposed Urinal Suitable for Waterless Starter/Conversion Kits

BAL500-WL

Standard Exposed Urinal Suitable for Waterless Urinal Starter/Conversion kits (sold separately)

If you're considering transitioning to waterless urinals and need to replace some or all of your existing urinal bowls, our standard 50cm urinal offers the ideal solution. The classic tear drop shape of this urinal will not look out of place in any washroom.

The spreader hole option provides the flexibility to install a low-flushing solution or convert the urinal back to flushing if needed. On the other hand, the no spreader hole option does not have a hole in the ceramic for a flushing nozzle, making it a genuine waterless urinal.

Please select your chosen waterless urinal starter/conversion kit form the related products below.

Bowl Dimension Options:
500mm Width = 383mm Projection from wall = 303mm
400mm Width = 295mm Projection from wall = 240mm

• Wall mounted urinal in vitreous china
• Large 500mm Height by 383mm Width Option
• Compact 400mm Height by 295mm Width Option
• Similar in design to more expensive brands
• Spreader hole option allows for a low flushing option to be installed.

Pack includes:
- 1 x 50cm or 40cm height Exposed Urinal
- 1 x Pair of  Urinal Wall Hangers
- 1 x Spreader hole blanking stopper if selected

£120.00

 (ex VAT)
Marfa Ceramic Waterless Urinal – Choice of Waterless Systems Available

Marfa Ceramic Waterless Urinal – Choice of Waterless Systems Available

MARFA-UO

Marfa Waterless Urinal – Choose your preferred waterless system from the available options above.

The Marfa Ceramic Waterless Urinal helps reduce water consumption in commercial washrooms. Its modern design features clean lines and a shroud that conceals waste outlet connections, while still allowing access for maintenance. The urinal is suitable for both horizontal concealed and vertical exposed pipe installations.

We offer a range of waterless urinal systems, including Microbiological and Valve Barrier Systems, all specifically designed to prevent odours and blockages. Choose the option that best suits your needs to complete your purchase.

Microbiological System: Aquafree UMD - Replaceable cartridges with microbes break down urine into odourless components. Simple to install and easily connects to existing pipework. Works effectively even with imperfectly vented waste pipes. Regular sluicing is required, and incompatible cleaning products can disable the system.

Valve Barrier Systems: GW6-15 & Falcon HP Key Valve - One-way valves block foul drain odours and must be connected to well-vented pipework WITHOUT traps. Typically has a longer lifespan, with the Falcon HPKV Version featuring a visual indicator for when replacement is needed. Weekly sluicing is recommended and incompatible cleaning products can damage the valves.

All systems require maintenance and the use of suitable cleaning products for optimal performance, but their significant water savings make them a highly beneficial solution.

Urinal Dimensions:
Height: 575mm, Width: 340mm, Projection from wall: 355mm, Weight: 14kg

• Wall mounted waterless urinal in vitreous china
• Choice of waterless system options available
• Suitable for exposed (vertical) or concealed (horizontal) pipework
• Open shroud design allows easy access for pipework maintenance
• Specifically designed waterless urinal with no spreader hole

Includes:
- 1 x Marfa Ceramic Waterless Urinal
- 1 x Wall Fixing Bracket Kit
- Your selected Waterless Urinal System (if chosen)

THIS PRODUCT IS USUALLY DELIVERED IN 2-4 WORKING DAYS VIA OUR STANDARD PALLET SERVICE
Please check pallet service delivery restrictions in the "About Delivery" tab before ordering.

£130.00

 (ex VAT)
Low Flush Urinal Cistern Timer (1-15 hour) Cistern Purge

Low Flush Urinal Cistern Timer (1-15 hour) Cistern Purge

UC01-011

This Low Flush controller can initiate a flush every 1-15 hours so that the standing water in the cistern and flush pipes will be regularly 'purged', thus usually avoiding the need to carry out a dead-leg procedure to minimise the risk of legionella.

Includes:
- flush controller box to affix to wall
- solenoid valve for connection to water supply
- 6v lithium battery (ref D058) or power transformer depending on chosen option.
- leads for connecting the various components
 
Features:
- typical savings of 95% on water costs
- flush frequency can be set between 1 and 15 hours in 1 hour increments.
- extremely reliable and low maintenance
- very low power consumption - typical battery life of 5 years (battery model)
- single valve output
- valve open button
- adjustable cistern fill time (15 mins 45 sec max) in 15 second intervals.
- box style may vary from illustration.
- transformer to connect to mains electricity supply (mains model)
 
Flush timer Instruction Manual
           'FCV01 / UC01-010/011 Low flush Timer' Instruction Manual
 

£179.00

 (ex VAT)

Waterless Urinal Starter Kits and Retrofit Solutions for Standard Urinals